蒙城华人网

标题: 车点不着火 [打印本页]

作者: shouqibao    时间: 2006-7-26 13:27
标题: 车点不着火
从去年秋天起,我的车一直没开。昨天想重新启动,可打不着火。到商店买了一个新电瓶,换上了,点火,只发出嗒嗒嗒嗒的声,却点不着。反复了3-4次,再点时却什么声音也没有了。油表显示有油,可为何点不着火啊?!求救!请大家帮忙啊!
作者: montrealchy    时间: 2006-7-26 13:31
标题: 把汽油还掉
把汽油还掉
作者: s2008    时间: 2006-7-26 15:50
may be low power, recharge the battery.
作者: shouqibao    时间: 2006-7-26 19:56
我可是在商店里花了90多刀新电瓶,也要重新充电吗?
作者: jzmtl    时间: 2006-7-27 00:41
Sounds like starter
作者: last    时间: 2006-7-27 09:36
你的情况,1:机油老化,活塞阻力大,转不动。
2:火花塞蒙垢点火难。3:汽油含水。可以先换汽油;不行的话再清洁火花塞;保持电瓶充祝,有耐性,多试。等打着火后去换机油。
作者: shouqibao    时间: 2006-7-27 13:44
谢谢大家的帮助!
我还想再问一个问题,机油我会换,箱子底下有一个口,把油放了就是了。但汽油怎么换,箱底也有个口吗?还是用管子吸?能换干净吗?另外,可否用个大桶到加油站加油呀?
作者: Protel    时间: 2006-7-27 19:59
换汽油? 有没有搞错阿?汽油根本用不着换的。就算是汽油内有水份,那么把车钥匙转到收音机响的位置,然后把脚踩在油门上一两分钟,油路就会循环,新油进入燃烧室而同时以前存在燃烧室的油沿回油管回到油箱。

你的问题感觉上是点火系统的问题。去Canadian Tire 买一罐 “Ignition system DRY and go" 喷洒你车上点火系统的Ignition wire以及Distributor Cap. 应该能解决问题。如果点火还是有问题,就一边点火(手转动钥匙)同时脚轻轻踩着油门。

机油的话把标尺拉出来查看是否混浊,如果油清的话根本不用换。机油放在车里和存放在油桶内有什么区别?半年没开车机油就老花了?有没有搞错阿?
作者: shouqibao    时间: 2006-7-30 16:50
多谢各位的回答。我现在想问 last 和 montrealchy, 我新买的电瓶换上了,今天也把机油换了,想再换汽油,不知怎么换。买了管子想用虹吸的方法,但管子只能进去50cm就再也伸不进去了,拔出管子,头上根本就没接触到油,这可怎么办呀!现在点火时,一点声音都不出,就是打不着。油表显示有两格的油,可为什么就打不着火啊! 急人那! 再次请教你们,该怎么办呀!
作者: last    时间: 2006-7-30 19:04
如果确实没有声音:1 电瓶电不足,不足以驱动starter; 2 starter有问题。既然开始的时候有塔塔声,stater应该在工作。 量一下电瓶,看是否要充电。换汽油实在很难,因为管线里的不好办。你现在先解决starter的问题。有了塔塔声再试其他。
good luck!
作者: montrealchy    时间: 2006-7-30 19:25
标题: 先看看你的电瓶,再检查一下起动机的接线是否良好
当时回答仓促,你先看看你的电瓶,要不要充电,再检查一下起动机的接线是否良好,因为电阻太大会造成无法启动,再就是拔出高压线,对缸盖放电,看看是否有高压火.还有一定要听一下在KEY ON时候油泵是不是转.大约5秒
换油吗比较难
GOOD LUCK
作者: shouqibao    时间: 2006-7-30 22:12
谢谢二位。我的电瓶是刚新买的,难道新买的电瓶都要先刺激一下。我以前从未摆弄过车,遇到问题都不知怎么办,多亏这个坛子及各位热心的网友。

starter 会有什么问题,该如何具体解决呢!再次请教各位。
作者: Protel    时间: 2006-7-31 11:47
虽然不建议你换汽油,但你一定要换的话,可以查看你车的Fuel filter在那里,绝大部分车的汽油虑油器位于车的底部,解开油管和虑油器的接头应该能够放完你油箱内的汽油。当然到了这个地步也就应该把虑油器也一起顺手换掉了。
作者: last    时间: 2006-7-31 13:21
It is a new battery, but this doesn't garantee the battery is full. Now that you tried many times, the battery is possibly low. By the way, do as montrealchy said, check the connections, it's very important. Clean the connectors at the two poles of the battery, because bad connections always add to the whole resistance in the starter loop. If only a 0.01 Ohm resistance was created, a significant drop on the voltage can happen, because the start current can be over 100Amps. Sometimes, if you spray some WD40 on the suspected connections, you could notice some tiny smoke rising from thr connectores when your helper turns the key to ignition position, but be sure the battery is full! If the battery is OK, the connections are OK, there is still no sound from the starter, that means a starter problem. You need to change it.
作者: jacy    时间: 2006-7-31 13:32
标题: recharge your new battery first
All new battery must be charged for actived it before you use it!

You can use the other car to try restart your car.

Goodluck!




欢迎光临 蒙城华人网 (https://www.sinoquebec.com/) Powered by Discuz! X3.1