nlc2003

我有Haynes manual, 自己换后刹车时还需要注意什么？
Thanks.

DonCherry

If it is disk brake, replacing it is as simple as the front brake, just take off
the caliper install the pads or pads/disk.

If it is drum brake. Be careful follow the diagrams in you manual, as step
by step basis. Because there are lot of springs, it might be able to give
you trouble if you fail to follow the steps.
Make sure there are not dust and clean before your final assembly. Don't
break the ruber seals on wheel cylinder.  Don;t over-tight or under tight
the hub nut, doing so may damage the bearing.

Drum brake is more difficult  than disk.

nlc2003

Thank you very much, DonCherry.