租房买房买生意上iU91
12
返回列表
楼主: 沙湾
打印 上一主题 下一主题

Don、Folks,请教!

[复制链接]   [推荐给好友]
11#
发表于 2003-10-20 20:39 | 只看该作者
不好意思, 冒昧问一下,FORKS大侠, 或者其他的朋友,NISSAN 200SX正常的轮胎压力是多少,我刚买的车,纯是菜鸟一个,所以问一个初级的问题,见笑。
回复 支持 反对

使用道具 举报

12#
 楼主| 发表于 2003-10-20 20:42 | 只看该作者
谢谢Folks和Kapagi, Phil Bailey好像是远了点儿,不知道205 ch.Bates是地址还是店名?另外有个问题,像我说的这种故障现象检查是否应该在有Hole的车行才行?问题太多,各位别嫌烦啊  wink
回复 支持 反对

使用道具 举报

13#
发表于 2003-10-20 21:05 | 只看该作者
正常的气压应在32 - 35 LBS 之间.注意一定要冷胎量.
回复 支持 反对

使用道具 举报

14#
发表于 2003-10-20 21:23 | 只看该作者
It'a shame to charge on this kind of job. Metal attrition noise is so easy to tell and need maximum 5 min to do so. I don't know why Canadiantire charge money on this.
回复 支持 反对

使用道具 举报

15#
发表于 2003-10-20 23:50 | 只看该作者
I agreed DonCherry's answer, almost 100% chance due to the water pump. For I have had such experience before.
Hi DonCherry, you are man expereinced and knowledge.
Could you tell me the possible problem for following
sympton:
Everyday the car is first started (cold start), the car is powerless whatever pressing gas pad, it runs around 20 to 40KM/h , but engine speed could be high as long as pressing hard on the pad, it needs to be drived 5 or 10 minutes before returning NORMAL
回复 支持 反对

使用道具 举报

16#
发表于 2003-10-21 11:09 | 只看该作者
Hi DonCherry, you are man expereinced and knowledge.
>>Thanks, please don't say that, I learned lot from friends here, guys like Folks, carman, louji, and others I cannot remember the name. Most of fellows here are warm-hearted and nice.


Could you tell me the possible problem for following
sympton:
Everyday the car is first started (cold start), the car is powerless whatever pressing gas pad, it runs around 20 to 40KM/h , but engine speed could be high as long as pressing hard on the pad, it needs to be drived 5 or 10 minutes before returning NORMAL

>>You must have an old car. The problem could involve lot things, but you can figure out one by one.
1)Does car easier to start? Does it easier to stall? If so, basically need a cleanup type of tune-up such a new air filter, new sparks/wires/distributor cap,rod, clean throttle body valve, etc.
If not, the mixture is not perfect when cold, not a big issue for old cars.
2)Cylinder lose pressure because of wore out. Nothing can do on this kind of lose.
3)Transmission is old, in vintage status, or fluid is to dirty. So it is slower to response/up-shifting.(Assuming it Is automatic transmission)

I think first two are main reasons. If it is old car, just drive as usual.
回复 支持 反对

使用道具 举报

17#
发表于 2003-10-21 22:24 | 只看该作者
Don Chery:
surely,it is a old van,Dodge voyager
"sparks" this is the part I want to check, V6 there are another three sparks in the rear side of engine, is very hard to replace or check.
wires/distributor cap/air filter have been replaced recently.
automatic transmission is old indeed, but avoid to touch, for it is too complicate to do that.
I do intend to have  a cleanup type of tune-up done in a inexpenesive garage, especially check/replace the sparks. Do you think if there is a good place to do that?
回复 支持 反对

使用道具 举报

您需要登录后才可以回帖 登录 | 免费注册

本版积分规则

Copyright © 1999 - 2024 by Sinoquebec Media Inc. All Rights Reserved 未经许可不得摘抄  |  GMT-5, 2024-11-25 07:13 , Processed in 0.046490 second(s), 35 queries .