Post by 秋刀鱼
cmos放电应该:1、拔电源插头,2、取下电池,3、跳线到‘放电’位置,等待半分钟后恢复跳线、电池,重新上电。
!!!
CMOS 放电:
1. 关机
2. Set 'clear cmos' to 1-2(3pin clear cmos) / place the jumper onto the 2pin(2 pin clear cmos)
3. press switch(Nothing will happen)
4. Set 'clear cmos' to 2-3 / take off the jumper from the 2 pins
5. switch on computer
6. press 'del' after beep to setup